S.I. No. 102/2023 - Irish Aviation Authority (Noise Certification and Limitation) Order 2023

1. The applicable noise requirements for an aircraft are prescribed according to the provisions of Chapter 1 of the Annex and

(a) for subsonic jet aeroplanes, in Volume I, Part II, Chapters 2, 3, 4 and 14, as applicable;

(b) for propeller-driven aeroplanes, in Volume I, Part II, Chapters 3, 4, 5, 6, 10, and 14, as applicable;

(c) for helicopters, in Volume I, Part II, Chapters 8 and 11, as applicable;

(d) for supersonic aeroplanes, in Volume I, Part II, Chapter 12, as applicable; and

(e) for tilt-rotors, in Volume I, Part II, Chapter 13, as applicable.

2. In the case of aeroplanes for which Chapter 2 or 12 of Annex 16, Volume I, Part II is applicable, the noise evaluation method shall be that prescribed in Appendix 1 of Annex 16, Volume I.

3. In the case of aeroplanes for which Chapter 3, 4, 5 or 14 of Annex 16, Volume I, Part II is applicable, the noise evaluation method shall be that pre- scribed in Appendix 2 of Annex 16, Volume I.

4. In the case of aeroplanes for which Chapter 6 of Annex 16, Volume I, Part II is applicable, the noise evaluation method shall be that prescribed in Appen- dix 3 of Annex 16, Volume I.

5. In the case of helicopters for which Chapter 8 of Annex 16, Volume I, Part II is applicable, the noise evaluation method shall be that prescribed in Appen- dix 2 of Annex 16, Volume I.

6. In the case of aeroplanes for which Chapter 10 of Annex 16, Volume I, Part II is applicable, the noise evaluation method shall be that prescribed in Appendix 6 of Annex 16, Volume I.

7. In the case of helicopters for which Chapter 11 of Annex 16, Volume I, Part II is applicable, the noise evaluation method shall be that prescribed in Appendix 4 of Annex 16, Volume I.

8. In the case of tilt-rotors for which Chapter 13 of Annex 16, Volume I, Part II is applicable, the noise evaluation method shall be that prescribed in Appen-dix 2 of Annex 16, Volume I.

9. The attachments to Annex 16, Volume I and the ICAO Environmental Technical Manual on the Use of Procedures for the Noise Certification of Air- craft, ICAO Doc 9501 AN/929 Volume 1, Third Edition —2018 should be used for the application of the Chapters and Appendices of Annex 16, Volume I.

EXPLANATORY NOTE

(

This Note is not part of the Order and does not purport to be a legal interpretation

)

This order gives effect to Annex 16, Volume I — eight edition, 2017, amendment 13 to the Chicago Convention except for aircraft within the scope of the EASA regulation. It revokes and replaces the Air Navigation (Noise Certification and Limitation) Order 2015. This Order is for the purpose of providing for enforcement and offences and for rights of access to and detention of aircraft in relation to noise certificates. This Order also gives effect to the Annex in respect of noise certification of aircraft where the EASA Regulation does not apply. Finally, the Order also provides for the making of such directions as may be necessary from time to time in respect of procedures for the limitation of noise made by aircraft in certain locations and in certain circumstances.

10. A noise certificate issued, or a noise certificate validated, under this Article shall cease to have effect if the aircraft is modified in any way which affects its compliance with the noise standards required by this Order.

11. An applicant requesting noise recertification shall furnish such evidence and shall submit the said aircraft to such tests (which may include tests in flight) as the Authority may require, for the purpose of proving compliance with the requirements of the Schedule to this Order. In such cases the date used by the Authority to determine the recertification basis shall be the date of acceptance of the first application for recertification.

Form of certificate

12. A noise certificate may take the form of a separate noise certificate or a suitable statement in another document approved by the Authority. The certificate or statement, as the case may be, shall include the following information, namely

item 1, the name of the state of registry;

item 2, the title of the noise document;

item 3, the number of the document;

item 4, the nationality or common mark and registration marks of the aircraft;

item 5, the manufacturer and manufacturer’s designation of aircraft;

item 6, the aircraft serial number;

item 7, the engine manufacturer, engine type and model;

item 8, the propeller type and model for propeller driven aeroplanes;

item 9, the maximum take-off mass in kilograms;

item 10, the maximum landing mass in kilograms, for certificates issued under Chapters 2, 3, 4, 5, 12 and 14 of the Annex;

item 11, the chapter and section of the Annex, according to which aircraft was certified;

item 12, additional modifications incorporated for the purpose of compliance with the applicable noise certification standards;

item 13, the lateral/full-power noise level in the corresponding unit for documents issued under Chapters 2, 3, 4, 5, 8, 12 and 14 of the Annex;

item 14, the approach noise level in the corresponding unit for documents issued under Chapters 2, 3, 4, 5, 8, 12, 13 and 14 of the Annex;

item 15, the flyover noise level in the corresponding unit for documents issued under Chapters 2, 3, 4, 5, 12 and 14 of the Annex;

item 16, the overflight noise level in the corresponding unit for documents issued under Chapters 6, 8, 10, 11 and 13 of the Annex;

item 17, the take-off noise level in the corresponding unit for documents issued under Chapters 8, 10 and 13 of the Annex;

item 18, a statement of compliance, including a reference to Annex 16, Volume I;

item 19, the date of issue of the noise certification document; and

item 20, the signature of the authorised officer of the Authority.

13. The item headings on the noise certification documents shall be uniformly numbered in Arabic numerals, as indicated in Article 12 of this Order, so that on any noise certification document the number will, under any arrangement, refer to the same item heading, except where the information in items 1 to 6 and items 18 to 20 are given in the certificate of airworthiness, in which case the numbering system of the certificate of airworthiness according to Annex 8 to the Chicago Convention shall prevail.

Revocation of certificates

14. The Authority may suspend, revoke, or vary a noise certificate, validation, approval, or other document issued under this Order upon evidence that the aircraft has been modified in any way which affects its compliance with the noise standards required by this Order.

15. The holder or a person having possession or custody of a noise certificate, validation, approval or other document which has been revoked, suspended or varied under this Order shall surrender it to the Authority within a reasonable time after being required by the Authority to do so.

16. The breach of a condition subject to which a noise certificate, validation, approval or other document has been issued under this Order shall render the document invalid during the continuance of the breach.

17. A noise certificate shall be carried in the aircraft to which it applies, save that if a flight by that aircraft is intended to begin and end at the same aerodrome or heliport within the State without passing over the territory of any other state and without an intermediate landing at another aerodrome or heli-port, the noise certificate may be kept at the first-mentioned aerodrome or heliport.

18. The pilot-in-command of an aircraft, on being required by the Company to produce or cause to be produced for inspection by an authorised officer of the company the noise certificate in force in respect of the said aircraft, shall produce or cause to be produced the said noise certificate.

19. A person shall not

(a) forge or fraudulently alter, or procure to be forged or fraudulently altered, or assist in forging or fraudulently altering a noise certificate;

(b) use a noise certificate required under this Order which has been forged, fraudulently altered, revoked or suspended or has ceased to be in force;

(c) give or lend a noise certificate to another person or, allow or permit it to be used by another person; or

(d) make, procure to be made or assist in making, a false representation for the purpose of procuring for himself or herself or for another person the issue, validation, renewal or variation of a noise certificate

Enforcement

20. Whenever it appears to the Authority or an authorised officer of the company that an aircraft is intended or likely to be flown from a place in the State in such circumstances that the flight would be a contravention of Article 5 of this Order or of another provision of this Order or a direction made thereunder, the Authority or authorised officer of the company may give to the operator of the aircraft or to the pilot-in-command thereof such instructions, and take such steps for the detention of the aircraft or otherwise, as appears to be necessary in order to prevent the flight.

21. The operator or pilot-in-command of the aircraft shall, unless there are reasonable grounds not to do, comply with every instruction given pursuant to Article 20.

22. For the purposes of Article 20, the Authority or an authorised officer of the company may enter upon and inspect an aircraft.

23. The Authority or an authorised officer of the company may, for the purpose of ascertaining compliance with the provisions of this Order, have access at all reasonable times to any aerodrome or place within the State for the purpose of inspecting either an aircraft on the said aerodrome or place or a document which under this Order he or she has power to demand or for the purpose of detaining an aircraft under this Order.

24. A person shall not wilfully obstruct or impede an authorised officer of the company acting in the exercise of his/her powers or the performance of his/her duties under this Order.

25. The Authority may give directions in respect of such matters and things as may be specified in this Order for carrying out the purposes of this Order and the Schedule thereto.

26. Directions under this Order may be given in the form of Notices to Airmen (otherwise known as NOTAMS), Notices to Aircraft Owners and Aircraft Engineers (otherwise known as Aeronautical Notices), Aeronautical Information Circulars published on the website of the Authority, or by notice or letter sent by registered post, or by email, to the person or organisation affected.

27. The Authority may exempt a class or classes of aircraft by direction from a provision of this Order.

28. Any person who fails to comply with the direction given by the Authority or an instruction given by an authorised officer of the company under a pro- vision of this Order shall be deemed for the purpose of this Order to have contravened that provision.

29. The Irish Aviation Authority (Noise Certification and Limitation) Order 2015 (

S.I. No. 55 of 2015

) is hereby revoked.

30. Notwithstanding the revocation of the Air Navigation (Noise Certification and Limitation) Order 2015, any noise certificate issued or validated under that Order and in force at the commencement of this Order shall remain in force and shall be deemed for all purposes as if it were a noise certificate issued under this Order.

Present when the common seal of the Irish Aviation Authority was affixed hereto

7 March 2023

ROSE HYNES,

Director

ERNIE DONNELLY,

Director

SCHEDULE

Notice of the making of this Statutory Instrument was published in

“Iris Oifigiúil” of

10

th March,

2023.

The Irish Aviation Authority, in exercise of the powers conferred on it by

sections 58

,

59

,

60

,

65

and

67

of the

Irish Aviation Authority Act, 1993

(No. 29 of 1993) as amended and for the purpose of giving effect to Annex 16 of the Chicago Convention, hereby orders